Closing The Blade Server Cover - IBM BladeCenter HS22 Installation And User Manual

Closing the blade server cover

Use these instructions for information about how to close the blade server cover.
Attention: You cannot insert the blade server into the BladeCenter unit until the
cover is installed and closed or an expansion unit is installed. Do not attempt to
override this protection.
To close the blade server cover, complete the following steps:
1. Read the safety information that begins on page "Safety" on page v and
2. Close the DIMM access door by rotating the door towards the DIMM
3. If you removed an expansion unit from the blade server, install it now (see
4. Lower the cover so that the slots at the rear slide down onto the pins at the
5. Pivot the cover to the closed position, as shown in the illustration, until it clicks
50
BladeCenter HS22 Type 7870 and 1936: Installation and User's Guide
"Installation guidelines" on page 21.
connectors.
"Installing an optional expansion unit" on page 25).
rear of the blade server, as shown in the illustration. Before you close the cover,
make sure that all components are installed and seated correctly and that you
have not left loose tools or parts inside the blade server.
into place.