Installing A Microprocessor And Heat Sink - IBM BladeCenter HS22 Installation And User Manual

6. Move the retaining clips on the ends of the DIMM connector to the open
7. Using your fingers, pull the DIMM out of the connector.
8. Install a DIMM or DIMM filler in each empty DIMM connector (see "Installing

Installing a microprocessor and heat sink

Use this information to install a microprocessor and heat sink in the blade server.
The following illustration shows how to install a microprocessor and heat sink in
the blade server.
Microprocessor
heat sink filler
Note: If you install an additional microprocessor, it must have the same type,
speed, and power specifications as the first microprocessor.
To use SMP, obtain an SMP-capable operating system. For a list of supported
operating systems and other optional devices, see http://www.ibm.com/servers/
eserver/serverproven/compat/us/.
34
BladeCenter HS22 Type 7870 and 1936: Installation and User's Guide
position by pressing the retaining clips away from the center of the DIMM
connector.
Note: To access DIMM connector seven through twelve, use your fingers to lift
the DIMM access door.
a memory module" on page 29).
Note: A DIMM or DIMM filler must occupy each DIMM socket before the
blade server is turned on.
Heat sink
Microprocessor 2
Microprocessor 1
and heat sink