Completing The Installation - IBM BladeCenter HS22 Installation And User Manual

Completing the installation

To complete the installation, complete the following tasks.
1. Reinstall the optional expansion unit, if you removed one to install other
2. Close the blade server cover, unless you installed an optional expansion unit
3. Reinstall the blade server into the BladeCenter unit (see "Installing the blade
4. Turn on the blade server (see "Turning on the blade server" on page 18).If you
5. For certain optional devices, you might have to run the blade server Setup
devices (see "Installing an optional expansion unit" on page 25 for information
on installing the expansion unit).
that has its own cover (see "Closing the blade server cover" on page 50).
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade server cover before installing the blade
server.
server in a BladeCenter unit" on page 51).
have just connected the power cords of the BladeCenter unit to electrical
outlets, you must wait until the power-on LED on the blade server flashes
slowly before you press the power-control button.
utility to configure the blade server (see Chapter 4, "Configuring the blade
server," on page 55). See the documentation that comes with your optional
device for additional information.
Chapter 3. Installing options
49