Belkin F1DN104K User Manual page 40

APPENDIX A – Secure KM Configuration Utility Software (KMC Creator)
SECTIONS
Table of Contents
Step 5 – Place the Displays and Create the Geometry
In the stage, the administrator will create his displays setup. The
administrator can drag and drop the monitors that were created in
proportion that reflect the size and shape of his actual monitors until
he creates a view similar to his real environment.
Each display is clearly marked by his computer number and monitor
number as entered by the administrator in the previous stage.
Monitors can be connected side by side or set apart, based on
the actual geometry required.Once the monitors are placed, yellow
"bridges" will indicate the area in which the mouse "teleports" itself
from one monitor to another.
Clicking on one of these areas will remove it, which will prevent
the mouse cursor from "teleporting" through this bridge. To enable
the bridge between monitors, just drag one monitor to the desired
monitor, having them touch each other. Pull apart the monitors, and
the bridge should appear between the monitors again.
Advanced Secure Keyboard/Mouse (KM) Switch
1 2 3 4 5
Examples:
Example 1 - The following setup creates a corridor from the top right of
monitor 2 computer 2 to the top bottom left of monitor 1 computer 1.
Trying to drag the mouse through the red lines will not work.
Example 2 – Both configurations below create identical setups in which
the mouse cursor moves from the right of computer 2 to the left of
computer 1.
38
6 7 7 8 9