Belkin F1DN104K User Manual page 30

OPERATING THE SECURE KM SWITCH
SECTIONS
Table of Contents
(Figure 5 – Pre-Defined Configuration List – Applies to 8-Port KM
Version Only - Using CTRL, CTRL, F11, x, x)
Advanced Secure Keyboard/Mouse (KM) Switch
1 2 3 4 4 5
Note: The KM Configuration Utility Tool is designed to be used
by administrators only for configuring the display layout for each
deployment environment if the predefined configuration list does not
accommodate the needs of the user's multiple monitor layout.
Mouse Speed Setting
Constant mouse cursor speed is essential for system usability.
Having several systems each with a different cursor "ground speed"
is detrimental for the user. Belkin's Secure KM Switch calculates and
adjusts the cursor speed across different displays and computers
using the geometry and display settings entered by the administrator.
In addition, the Switch settings include a global speed setting with
input values between 1 and 10, which can be changed to adjust the
cursor speed for all displays. Typical initial setting of cursor speed is
5. After initial use, the exact value can be set based on user inputs.
To increase mouse speed, press CTRL, CTRL, F11, +
To decrease mouse speed, press CTRL, CTRL, F11, -
SCS Enabled/Disabled Setting
Through the SCS enabled/disabled setting, you can disable the
mouse cursor tracking function. Once SCS is disabled, the Switch will
enable channel selection only through:
1. Front-panel push buttons
2. Keyboard shortcuts, and
3. DCU (if connected)
Note: This setting is enabled by default.
28
6 7 8 9