Mitsubishi Lancer Evolution-VI Workshop Manual page 44

11-20
Timing
marks
(on front
case)
ENGINE –
Timing Belt
"GA TIMING BELT "B" INSTALLATION
(1) Align timing marks on the crankshaft sprocket "B" and
counterbalance shaft sprocket with the marks on the front
Timing case respectively.
marks
(2) Install the timing belt "B" on the crankshaft sprocket "B"
and counterbalance shaft sprocket. There should be no
slack on the tension side.
(3) Make sure that the relationship between the tensioner
pulley center and the bolt center is as shown in the
illustration.
(4) Move the tensioner "B" in the direction of arrow while
lifting with a finger to give a sufficient tension to the tension
side of timing belt. In this condition, tighten bolt to secure
tensioner "B". When the bolt is tightened, use care to
prevent shaft from turning together. If shaft is turned
together, belt will be overtensioned.
(5) Check to ensure that timing marks on sprockets and front
case are in alignment.
(6) Press with index finger the center of span on the tension
side of timing belt "B". The bolt must deflect 5 – 7 mm.
"HA CRANKSHAFT BOLT TIGHTENING
(1) Using the special tool, hold the flywheel or drive plate.
(2) Install the crankshaft pulley in position.