Mitsubishi Lancer Evolution-VI Workshop Manual page 321

52B-30
<Driver's side>
Connector
<Front passenger's side>
Inflator case
Connector
Protective tube
Protective tube
SRS –
Air Bag Modules and Clock Spring
INSPECTION
Inflator case
AIR BAG MODULE CHECK
If any improper part is found during the following inspection,
replace the air bag modules with a new one.
Dispose the old one according to the specified procedure.
(Refer to P.52B-32.)
Caution
Never attempt to measure the circuit resistance of the
air bag modules (squib) even if you are using the specified
tester. If the circuit resistance is measured with a tester,
accidental air bags deployment will result in serious
personal injury.
1. Check pad cover for dents, cracks or deformation.
2. Check connectors for damage, terminals for deformation,
3. Check air bag inflator case for dents, cracks or
4. Install the air bag module to steering wheel to check
Caution
If dents, cracks, deformation, or rust are discovered in
the air bag module, replace it with a new one.
Dispose of the old one according to the specified
procedure. (Refer to P.52B-32.)
CLOCK SPRING CHECK
If, as result of following checks, even one abnormal point
is discovered, replace the clock spring with a new one.
Case
1. Check connectors and protective tube for damage, and
2. Visually check the case for damage.
and harness for binds.
deformation.
fit or alignment with the wheel.
terminals for deformation.