Mitsubishi Lancer Evolution-VI Workshop Manual page 326

Body wiring harness
connector
(2-pin)
Air bag module 2-pin
connector (red)
Connection
Insulation
tape
SRS air bag
adapter
harness A
MB686560
SRS air bag adapter
harness A
MB686560
2-pin connector (red)
Deployment wires
Deployment
wire harness
SRS –
Air Bag Module Disposal Procedures
6 m or
longer
Two wires
Body cover
<Air bag module (front passenger's side)>
(1) Remove the glove box. (Refer to P.52B-27.)
(2) Remove the connection between the air bag module
(front passenger's side) connector (red 2-pin) and
the body wiring harness connector.
(3) Connect two wires, each six meters or longer, to the
two leads of SRS air bag adapter harness A and
cover the connections with insulation tape. The other
ends of the two wires should be connected to each
other (short-circuited), to prevent sudden unexpected
deployment of the air bag.
(4) Connect the clock spring or air bag module (front
passenger 's side) 2-pin connector (red) to SRS air
bag adapter harness A and pass the deployment
wires out of the vehicle.
(5) Shut all the doors with their window glasses closed
and cover the vehicle with a body cover to suppress
explosion noise leaks as much as possible.
Caution
Be sure to wrap the vehicle entirely in a body cover,
otherwise damaged glass panes could break into
fragments, bringing about a very dangerous situation.
(6) At a location as far away from the vehicle as possible,
disconnect the two connected wires from each other,
and connect them to the two terminals of the battery
(which has been removed from the vehicle) to deploy
the air bag.
52B-35