Remote Phone Control Feature; Keypad Functions - Honeywell ADEMCO LYNXR Series Installation And Setup Manual

Speaker Phone Operation (LYNXR-EN Only)
To place a call or answer a call using the speaker phone:
To flash (switch between two calls using call waiting):
To hang up and exit speaker phone mode:
To enable/disable (toggle) ringer:
To return the keypad to telephone mode after disarming the system:

Remote Phone Control Feature

The remote phone control feature, which must be enabled in field
system from any off-site touch-tone telephone. The control will pick up the incoming call, based on the ring
count specified in field
seconds. During this period the panel will wait for a valid User Code to be entered. If a valid User Code is
not entered or the eight (8) second period expires a modem tone will be generated for remote programming
(Compass Downloading). If a valid User Code has been entered, the control will announce the current system
status and/or beeping sounds.

Keypad Functions

Remote Phone Control Feature
To remotely disarm system:
To remotely arm in AWAY mode:
To remotely arm in STAY mode:
To remotely arm in AWAY or STAY with no delay:
To remotely activate X-10 devices 1-6: [#] + [4] + device no.
To remotely activate X-10 devices 7 & 8:
To remotely deactivate X-10 devices 1-6: [#] + [7] + device no.
To remotely deactivate X-10 devices 7 & 8:
To remotely Bypass zones:
To remotely activate Forced Bypass:
To remotely check system status: [
To end remote phone control session: Hang Up or
OFF
[#] +
VOLUME
✻
95, and will announce "SYTEM" every three (3) seconds for the next eight (8)
+ [1]
+ [6] + zone no.
]
✻
–49–
System Operation
The ARMED and READY LEDs blink alternately
[#] +
AUX
when the Speaker Phone is active.
AUX
+
AUX
[#] +
✻
91, allows the user to access the security
+ [2]
+ [3]
+ [2] or [3] + [0]
+ [#] + [4] + device no.
+ [#] + [7] + device no.
+ [6] + [#]
+ [9]
NOTE
AUX
Quick Arm Note
The installer code and
babysitter code cannot
disarm the system if
armed by Quick Arm
method.