Record Custom Voice Descriptors - Honeywell ADEMCO LYNXR Series Installation And Setup Manual

✻

85 Record Custom Voice Descriptors

Use this mode to record up to 5 custom voice descriptors. Press
Note: Entering a number other than one specified will give unpredictable results.
Assign custom voice descriptors
0 = exit mode
85
1 = enter mode
Custom descriptor number
d
Enter 7 + d + [✻]
A 7
Where d = 0-4, each representing custom
word 70, 71, 72, 73, or 74, respectively. Any
existing word will be announced.
Press [#] to start recorder. Begin speaking
immediately after the third beep.
Speak the desired word clearly near the
microphone. Recording stops after 1.5
seconds.
6 = accept word and ready to record next
descriptor prompt (A....7d)
[#] = re-record descriptor
00 = exit Record mode after pressing 6 to
accept word
Press any key to repeat the recorded word.
✻ 85 while in Programming mode.
Entering "1" advances to the next prompt below.
Entering "0" exits mode, upon which this prompt blinks, indicating the
mode is inactive.
Record up to 5 custom words.
–40–