Remote Access - Philips S10 User Manual

1
Tap from the main menu screen.
2
Select [Ring delay].
3
Select a new setting.
» The setting is saved.
Note
•
The answering machine needs to be switched on
before applying this setting.
Set the sound quality of the message
You can adjust the sound quality of the
messages received from the answering machine.
1
Tap from the main menu screen.
2
Select [Message quality].
3
Select the new setting.
» The setting is saved.
Note
•
The sound quality can only be adjusted before
recording starts.
•
Depending on the sound quality, the maximum
number/length of recorded messages changes. In high
quality setting, a maximum of 15 mins of messages can
be stored. In the low quality setting, approximately 60
minutes can be stored.

Remote access

You can operate your answering machine when
you are away from home. Simply make a call to
your phone with a touch tone phone and enter
your 4-digit PIN code.
Note
•
The remote access PIN code is the same as your
system PIN. The preset PIN is 0000.
Activate/deactivate the remote access
You can allow or block remote access to the
answering machine.
30 EN
1
Tap from the main menu screen.
2
Select [Remote access].
3
Tap the switch to turn it on or off.
» The setting is saved.
Tip
•
When you access the answering machine remotely,
you are recommended to set the ring delay to[Toll
saver] mode. This is a cost effective way to manage
your messages. When there are new messages, the
answering machine picks up the call after 3 rings.
When there is no messages, it picks up the call after
5 rings, giving you the opportunity to hang up before
a connection is established in case there are no new
message.
Change the PIN/passcode
1
Tap from the main menu screen.
2
Select [Remote access] > [Change PIN].
3
Enter the old remote access PIN/passcode,
then tap [OK] to confirm.
4
Enter the new remote access PIN/
passcode, then tap [OK] to confirm.
5
Enter the new remote access PIN/
passcode again, then tap [OK] to confirm.
» The setting is saved.
Access the answering machine remotely
1
Make a call to your home number with a
touch tone phone.
2
Enter # when you hear the announcement.
3
Enter your PIN code.
» You now have access to your
answering machine, and you can listen
to the new messages.
Note
•
You have 2 chances to enter the correct PIN code
before your phone hangs up.
4
Press a key to carry out a function. See the
Remote access commands table below for
a list of available functions.