replacement batteries through the Philips
website or Philips service.
Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
Use only the supplied battery.
Charge the battery for 6.5 hours before first use.
Check the battery polarity when inserting in the
battery compartment. Incorrect polarity may damage
Check your phone's software
Before setting up your phone, make sure you
have the latest software available for your
Install the [Philips Phone Manager]available
for free at www.philips.com/support (see
Connect the phone through a micro USB
cable (available at most electronics stores
or through Philips service network).
If a new software is available, the [Philips
Phone Manager] will display a message.
You can also check the current software version
> [Firmware version] and compare it
with the software version displayed at www.
Configure your phone
Turn your phone on/off
until you see the Philips wordmark.
Set the country/language
Select your country/language, then tap
» The country/language setting is saved.
The country/language setting option is country
dependent. If no welcome message is displayed, it
means the country/language setting is preset for your
country. Then you can set the date and time.
To re-set the language, see the chapter
'Settings', section 'Phone settings'.
Set the date and time
Set your date, date format, time and time
format, then tap [Apply]to confirm.
You can tap [Advanced setup] to set the [Eco
mode], [ECO+ mode] or [Silent mode]. For
information, refer to the chapter on [Phone
To set the menu under [Advanced setup] later, press
[OK] to skip this setting.