HP Omnibook XT6050 Service Manual page 54

Component
Doors, PCMCIA
Heatsink (with fan)
Keyboard
Panel, sound/IR
Panel, mini-PCI
PCA, display interface
PCA, front antenna
(wireless models only)
2-32 Removal and Replacement
Removal Procedure
Plug-in module
(page 2-5).
Hard disk drive (page 2-7).
Power button panel
(page 2-11).
Keyboard (page 2-13).
Heatsink (page 2-15).
Display assembly
(page 2-19).
Top case (page 2-21).
See page 2-15.
See page 2-13.
Plug-in module
(page 2-5).
Hard disk drive (page 2-7).
Power button panel
(page 2-11).
Keyboard (page 2-13).
Heatsink (page 2-15).
Display assembly
(page 2-19).
Top case (page 2-21).
Plug-in module
(page 2-5).
Hard disk drive (page 2-7).
Power button panel
(page 2-11).
Keyboard (page 2-13).
Heatsink (page 2-15).
Display assembly
(page 2-19).
Top case (page 2-21).
Plug-in module
(page 2-5).
Hard disk drive (page 2-7).
Power button panel
(page 2-11).
Keyboard (page 2-13).
Heatsink (page 2-15).
Display assembly
(page 2-19).
Top case (page 2-21).
Plug-in module
(page 2-5).
Hard disk drive (page 2-7).
Power button panel
(page 2-11).
Keyboard (page 2-13).
Heatsink (page 2-15).
Display assembly
(page 2-19).
Top case (page 2-21).
Additional Steps
See the figure on page 2-25.
Reassembly Notes: Insert the tabs on the ends of the
panel into the slots in the bottom case.
On the rear of the computer, remove the screw at the
far left end (nearest the mini-PCI panel). Detach the
cables from mini-PCI card and motherboard.
Unplug the speaker cable, and carefully lift the PCA off
of its connector.
Disconnect the front antenna PCA flex cable from the
motherboard, and the coaxial cable from the mini-PCI
card (see Figure 2-19 on page 2-26).
HP Omnibook XT6050, XT/VT6200