Removal And Replacement; Table 2-1. Removal Cross-Reference - HP Omnibook XT6050 Service Manual

This chapter tells you how to remove and replace the Omnibook's components and assemblies. The
items marked by in the following table are user-replaceable.
Battery, main (page 2-4).
Battery, CMOS (page 2-31).
Bumpers, display (page 2-12)
Cap, pointing stick (page 2-12).
Card, mini-PCI #1 (page 2-10).
Card, mini-PCI #2 (page 2-31).
Case, bottom (page 2-23).
Case, top (page 2-21).
Cover, center hinge (page 2-31).
Cover, left corner (page 2-12).
Cover, mini-PCI (page 2-12).
Cover, SDRAM (page 2-12).
Cover, right corner (page 2-12).
Covers, screw (page 2-12).
CPU module (page 2-17).
Display assembly (page 2-19).
Doors, docking (page 2-25).
Doors, PCMCIA (page 2-25).
Caution
Always provide proper grounding when performing repairs. Without proper
grounding, an electrostatic discharge can damage the Omnibook and its
components.
Notes
Reassembly steps are the reverse of the removal steps. Reassembly notes are included at the end
of each section below.
Symbols like this throughout this chapter show approximate full-size screw outlines. You can
use these to verify the sizes of screws before you install them. Installing a wrong-size screw can
damage the unit. (The symbol at the left represents an M2.5×5mm T-head screw.)
HP Omnibook XT6050, XT/VT6200

Removal and Replacement

Table 2-1. Removal Cross-Reference

Drive, hard disk (page 2-7).
Feet, rubber (page 2-12).
Heatsink (with fan) (page 2-15).
Keyboard (page 2-13).
Panel, sound/IR (page 2-32).
Panel, mini-PCI (page 2-32).
Panel, power button (page 2-11).
PCA, display interface (page 2-32).
PCA, motherboard (page 2-23).
PCA, volume (page 2-33).
PCA, front antenna (page 2-32).
PCA, rear antenna (page 2-33).
Plug-in module (page 2-5).
SDRAM module (page 2-6).
Socket, PCMCIA (page 2-33).
Speaker assembly (page 2-33).
Tray, hard disk drive (page 2-7).
Removal and Replacement
2
2-1