Table of Contents
Advertisement
TOP LOAD WASHER HELP MODE
This mode is entered by pressing the LOWER LEFT key pad while in special pricing option mode 2.XX (or
while dAS displays if operating with Maytag Data Acquisition setup). In help mode, the LOWER MIDDLE key-
pad can be used to advance through three help codes (displayed as 1h.XX, 2h.XX and 3h.XX). Pressing the
LOWER RIGHT keypad while any of the help codes are displayed clears the help codes. The help modes are
followed by the Energy Saving indication screen (displayed as hE.ES), the software version, and finally the
water temperature sensing screen (displayed as Exxx). Press the LOWER LEFT keypad at anytime to exit
help mode.
The Energy Saving indication screen (hE.ES) and temperature sensing screen (Exxx) will only be displayed if
the washer is configured for energy saving operation. The water temperature sensing screen (displayed as
Exxx) is not a measure of water temperature in °F, but higher numbers do correspond to higher temperature
water.
In help mode, other display symbols and elements are mapped to reflect the state of various inputs and
outputs as follows:
WASH.............................................. water sensed at wash level
* ....................................................... low voltage present (below about 180 VAC)
circle above digit ........................... lid closed
OR ................................................... motor sensed running
COLD .............................................. cold water relay on
HOT ................................................. hot water relay on
DETERGENT or SMALL LOAD ...... motor relay on
SPIN ................................................ spin (reversing) relay on
AVAILABLE..................................... energy saving strap present
FINAL INSTALLATION CHECKLIST
__________ Tub block and instruction package have been removed from tub.
__________ Agitator is secured on the shaft.
__________ Washer is plugged into electrical outlet and is properly earthed.
__________ Water is turned on and checked for leaks at the tap and water valve connections.
__________ Drain hose is properly located into drain facility and is not collapsed or damaged.
__________ Washer has been leveled as close to the floor as possible. All legs should be firmly on the
floor and leveling leg lock nuts MUST be tightened.
__________ Washer fills properly on all temperature selections.
__________ Agitate – after washer has filled.
__________ Spin – be sure washer spins and drains.
__________ Open lid to be sure washer does not continue spinning.
Make any corrections necessary to properly complete the installation.
13
Hide quick links:
Advertisement
Table of Contents
