Cord Wrap On Charger - Philips Sonicare FlexCare Platinum Instructions Manual

1 Attach your brush head to the handle.
2 Place the handle on the plugged-in charger
or sanitizer.
3 Activate or deactivate Easy-start:
, To activate Easy-start: Press and hold the power
on/off button for 2 seconds. You hear 2 beeps
to indicate that the Easy-start feature has been
activated.
, To deactivate Easy-start: Press and hold the
power on/off button for 2 seconds. You hear
1 beep to indicate that the Easy-start feature
has been deactivated.
Note: Each of the first 14 brushings must be at least
1 minute in length to properly move through the
Easy-start ramp-up cycle.
Note: Using the Easy-start feature beyond the initial
ramp-up period is not recommended and reduces
Sonicare's effectiveness in removing plaque.
Cord wrap on charger (select models)
If your model includes the charger cover and base,
the travel charger is pre-installed inside the cover.
1 To separate the charger cover from the
charger base, press the two gray snap bars on
the charger base and pull the white charger
cover upwards.
2 Wrap excess power cord around the gray
charger base as shown in the picture. Be sure
to wrap the cord on the inside of the two snap
levers. Guide the power cord through the small
groove in the rear of the charger base.
EngliSh
13