Selecting A Setting For A User Program - Sharp AR-168S Service Manual

2. Selecting a setting for a user program

1) Press the [MENU] key and then press the [ENTER] key.
In printer mode, the user programs are accessed by simply press-
ing the [MENU] key.
MAIN MENU
1:USER PROGRAM
] >
2) Press the [<] key [v or [ ] key [
configure in the USER PROGRAM items, and then press the
[ENTER] key.
• You can also select a program by directly entering the program
number with the numeric keys.
USER PROGRAM
2:PREHEAT MODE
< >
3) Press the [ ] key [v] or [
selected item.
PREHEAT MODE
1:30 SEC.
NOTE:
• If you mistakenly select the wrong item, press the [CLEAR] key [C]
and repeat the procedure from step 2).
• To cancel a setting for a user program, press the [MENU] key.
4) Press the [ENTER] key.
Your selection appears briefly and then the previous screen
appears.
NOTE:
When "AE LEVEL ADJUST" is selected in the user programs and the
[ENTER] key is pressed, the automatic exposure adjustment screen
appears. Adjust the exposure and press the [ENTER] key.
^]
to select the item that you wish to
] key [^] to change the setting of the
AR-168S/168D USER PROGRAM 12 - 3
Audible signals (key entry beep, invalid key beep, base setting
beep)
The machine sounds three different types of beep signals: a key
entry beep that sounds when a valid key is pressed, an invalid key
beep that sounds when an invalid key is pressed, and a base setting
beep that sounds when a setting is the same as the base setting
(base settings are explained below). The base setting beep is initially
disabled. If you wish to enable the base setting beep, see "SOUND
AT DEFAULT". If you wish to change the volume of the beep signals
or disable them, see "KEY TOUCH SOUND".
The beep patterns of each type of beep signal are as follows:
Key entry beep: One beep
Invalid key beep: Two beeps
Base settings
The base settings are preset standard selections for each copy set-
ting. The base settings are as follows:
Copy ratio: 100%
Light and Dark level: center
Base setting beep: Three beeps
Paper feed location:
Tray 1 (Upper paper tray)
AUTO/TEXT/PHOTO: AUTO