G Selecting A Setting For A User Program - Sharp AL-1633 Operation Manual

USER SETTINGS
SELECTING A SETTING FOR A USER PROGRAM
1
Hold down the [Light] key (
the alarm indicators (
blink.
1 3 5
2
Enter the program number with the
numeric keys.
READ END
If you enter the wrong number, press the
Note
[CLEAR] key (
number.
3
Press the [START] key (
Audible signals (key entry beep, invalid key beep, base setting beep)
The machine sounds three different types of beep signals: a key entry beep that sounds when a valid key is
pressed, an invalid key beep that sounds when an invalid key is pressed, and a base setting beep that sounds
when a setting is the same as the base setting (base settings are explained below). The base setting beep is
initially disabled. If you wish to enable the base setting beep, see "Base setting beep signal" on page 39. If you
wish to change the volume of the beep signals or disable them, see "Audible signals volume" on page 39.
The beep patterns of each type of beep signal are as follows:
Key entry beep ......................... One beep
Invalid key beep ......................Two beeps
Base settings
The base settings are preset standard selections for each copy setting. The base settings are as follows:
Copy ratio ........................................ 100%
Light and Dark indicator........................ 3
Paper feed location ....... Upper paper tray
40
) until
, , , )
The display shows "- -"
with the left hyphen
blinking.
• See "USER
PROGRAMS" (p.38 to
p.39) for the program
numbers.
• The selected program
number blinks.
• For example, to select
"Auto clear timer",
press the [1] key.
) and then enter the correct
).
• The selected program
number stops blinking
and lights steadily.
• The currently selected
setting code blinks on
the right side of the
display.
4
Enter the desired setting code by
pressing a numeric key.
If you enter the wrong number, press the
Note
[CLEAR] key (
5
Press the [START] key (
To select a setting for another user program,
Note
press the [CLEAR] key (
to step 2.
6
Press the [Light] key (
the settings.
The alarm indicators (
and the display returns to the number of copies
display.
Base setting beep ................ Three beeps
ORIGINAL SIZE........................................A4
AUTO/TEXT/PHOTO (
AUTO
............................................................ AUTO
• For the setting codes,
see "USER
PROGRAMS". (p.38 to
p.39)
• The selected setting
code blinks.
• For example, to select
90 seconds, press the
[5] key.
) and return to step 2.
).
The selected setting
code stops blinking and
lights steadily.
) and then return
) to complete
, , , ) go off
/ / )