Sharp AR-168S Service Manual page 111

Main Sub
Contents
code code
64 01 Self print (1by2 mode)
(SELF PRT.)
66 01 FAX soft SW setting
(Executable only when the
FAX is installed.)
02 FAX soft SW initializing
(excluding the adjustment
values) (Executable only
when the FAX is installed.)
[Function]
The status of the optical section is ignored and printing of one page is made. Also when the print com-
mand is received from the host, printing is made.
When this test command is executed, warm-up is performed and the ready lamp is lighted. (Since,
however, the scanner is disabled, initializing is not made.)
Enter the code number and press [ENTER/START] key to start paper feed from the selected cassette
and print in the selected pattern.
Code number Pattern
0 1by2
1 Grid pattern
2 White paper
3 Black background
For 4 – 99, flip.
[Operation]
The operation is similar to test command 21-01.
[Function]
Use to check the FAX soft SW setting.
Every time when the key is pressed, the bit on the first line is switched 0 and 1.
[Operation]
1) Initial display
ENTER FAX SOFT SW. #
(3 DIGITS) SW.___
[CLEAR] key: FAX control is terminated.
2) Enter a 3-digit value of soft SW No. (To
enter the fourth digit, shift to the left.), and
the press [ENTER] key.
No.### xxxxxxxx
CHANGE? 1:YES 2:NO
"xxxxxxxx" is the set content.
Select 2: Returns to the soft SW No. entry dis-
play.
[Function]
Use to initializing FAX soft SW.
[Operation]
1) Initial display
INITIALIZED
After 2sec, FAX control is terminated.
AR-168S/168D TEST COMMAND, TROUBLE CODES 10 - 31
Details of function/operation
Display item
1 BY 2
CHECK
WHITE
BLACK
3) Select 1
No.### xxxxxxxx
USE # KEY
4) Change with 1-8 of [10KEY] and the press
[ENTER] key.
No.### xxxxxxxx
STORED? 1:YES 2:NO
"xxxxxxxx" is the set content.
Select 2: Returns to the soft SW No. entry dis-
play.
5) Select 1
STORED
After 2sec, returns to "1) Initial display".
12345678