Table of Contents
Advertisement
OPERATION
Small Area Cuffing Pattern
Large Area Cutting Pattern
32
CUTTING PATTERNS
These cutting patterns are only recommended for
a flat, level lawn surface.
a
In
2
or 3 turns in
First make
then turn around and continue cutting in a
In a large area
The first round of cuts is the key to making a neat
finish. First, make 2 or 3 turns in a clockwise
direction.
As
you reach the center of the area, turn
to the right and begin cutting in a counter-clock-
wise direction until you have finished the the upper
half of the area. Cut the grass in the remaining half
in a counter-clockwise dire'ction.
Mowing unsquare areas
is
If your mowing area
not square or four-sided,
divide the area into several blocks so you
mow in a neat mowing pattern.
Overlapping o n straightaways
Be sure that each mowing lane overlaps suffi-
ciently. The recommended overlap width is be-
tween 4-6 inches or approximately
one of the mower's front tires.
curves and turns
Overlapping in
When cutting in curves and turns, shift to a slower
speed and be sure to overlap the previous cut by
20-50%
or approximately half the width of the
mower.
Uneven Terrain
not operate on steep slopes.
Do
not stop, start or change directions
Do
suddenly on slopes.
Use extreme care and reduce ground
speed on slopes and rough terrain. Watch
for hidden hazards o n the terrain during
operation.
Pass diagonally through sharp dips and avoid
sharp drops to prevent "hanging up" the tractor
and mower. Practice will improve your skills in
maneuvering rough terrain.
Take all possible precautions when leaving tractor
unattended: disengage mid-PTO; set parking
brake, stop engine, remove key and lower mower
to ground.
a
clockwise direction.
c a n
the
width of
Advertisement
Table of Contents
