Table of Contents
Advertisement
PROBLEM
1. Mower overloading; material too tall or heavy
2. Oil on belt from over-lubrication
3. Belt hung up or rubbing
Belt or pulleys worn out
4.
1. Damaaed belt
2. Worn pulley groove
1. Rollover, high shock loads or installation
damage
1. High shock loads
2. Belt came off driie
TROUBLESHOOTING
SOLUTION
2400 rpm. Cut material twice: one high pass,
then mow at desired height, Cut a partial swath.
2. Be careful not to over-lubricate. Clean lubricant
from belt and pulleys with clean rag. Replace
oil-soaked belt.
3. Check belt for free travel in pulleys and belt
guides. Check under mower and around blade
spindle shafts for wire, rags or other foreign ma-
terial. Clean all material from under mower.
4. If belt rides in bottom of pulley groove, either
belt or pulley is worn and must be replaced.
any other part while running.
1. Lay belt flat on floor. If belt does not lie flat (has
or
humps
twists), indicating broken
cords, it must be replaced.
2. Replace pulley.
1. Replace belt.
1. Avoid abusive mowing. Avoid hitting the ground
or
obstructions.
2. Check driie alignment for foreign material in
grooves. Avoid hitting solid objects or ground.
.
.
or
stretched
53
Advertisement
Table of Contents
