Table of Contents
Advertisement
MAINTENANCE
48
. . .
3. Clamp cup in vise as shown and tap on yoke
3. Clamp cup in vise as shown and tap on yoke
to completely remove cup from yoke. Repeat
to completely remove cup from yoke. Repeat
steps two and three for opposite cup.
steps two and three for opposite cup.
Place universal cross in vise as shown and tap
4.
on yoke to remove cup. Repeat step three for
final removal. Drive remaining cup out with drift
.and hammer.
Assembly
cup into yoke from outside and press on with
hand pressure
far
as
as
cross into bearing cup with grease fiiing away
from shaft. Be careful not to disturb needle
bearings. Insert another bearing cup directly
across from first cup and press in as far as
possible with hand pressure.
2. Trap cups in vise and apply pressure. Be sure
journal cross is started into bearings and
continue pressure with vise, squeezing in
as
possible. Tap yoke to
3. Seat cups by placing a drift (slightly smaller
than the cup) on cup and rapping with ham-
mer. Install snap ring and repeat on opposite
cup.
Repeat steps one and two to install remaining
4.
cups in remaining yoke.
5. Move both yokes in all directions to check for
free movement. Should movement be re-
stricted, rap on yokes sharply with a hammer to
relieve any tension. Repeat until both yokes
move in all directions without restriction.
possible. Insert
journal
as
far
aid
in process.
Advertisement
Table of Contents
