Honda MM60 Operator's Manual page 56

TROUBLESHOOTING
PROBLEM
1. Tractor speed too fast
2. Grass accumulation inside deck
3. Dull Blade
5. Mower not level
6. Wrong mower deck height
7. Engine speed too low
1. 'Blade driie belt worn or broken
2. Mid PTO not selected
3. Faulty PTO clutch or worn disk
2. Deck too low
3. Engine overloaded
Lawn wet or watered
5. Lawn too tall
Engine speed too low
6.
1. Cutting height too low
2. Tractor speed too high
3. Uneven surface
4. Rough and uneven surface
2. Driveblade belt damaged
3. Pulley(s) damaged or out of alignment
4. Lack of gearbox lubricant
1. Engine speed too low
2. Tractor speed too fast
Pebbles or other foreign matter are stuck
3.
in mower deck
54
SOLUTION
to lower gear.
2. Clean deck underside.
3. Have the blade sharpened or replace it.
4. Check the tire inflation.
5. Check the blade height.
6. Change to proper height.
7. Run at full throttle.
2. Check PTO Selector Lever position
3. See your authorized HONDA Multi-purpose
Tractor dealer.
1. Use genuine HONDA blade or equivalent.
2. Raise deck and adjust deck height properly..
3. Operate at full throttle. Use lower speed range.
Set mower deck higher than ,desired height for
first pass, then cut to desired height on second
pass.
Allow to dry before cutting.
5. Set mower deck higher than desired height for
first pass, then cut to desired height on second
pass.
Run at f u l l throttle.
6.
on Mid-PTO.)
1. Increase to proper height.
2. Lower to proper speed.
,
3. Change cutting pattern.
4. Adjust with height adjuster.
1. Adjust balance.
2. Replace.
3. See your authorized HONDA multi-purpose
tractor dealer.
Lubricate with SAE 90 weight gear lubricant
4.
1. Run at full throttle. (Do not exceed 2400 rpms
on Mid-PTO.)
2. Lower to proper speed range.
Remove.
3 .
(Do not exceed rpms