Table of Contents
Advertisement
OPERATING TECHNIQUE
Proper ground speed will depend upon the terrain,
the height, type and density of material to be cut.
Normally, ground speed will range from two to five
mph. Tall dense material should be cut at a low
speed; thin medium-height material can be cut at
a faster ground speed.
governed engine RPM. This is necessary to
maintain proper blade speed and produce a clean
cut.
Under certain conditions, tractor tires may roll
some grass down and prevent it from being cut at
the same height as the surrounding area. When
this occurs, reduce your ground speed, but
maintain maximum engine RPM. The lower ground
speed will permit grass to at least partially re-
bound.
Under some conditions, grass will not rebound
enough to be cut evenly. In general, lower cutting
heights give a more even cut with less tendency to
However,
leave tire tracks.
frequently rather than too short. Short grass
deteriorates rapidly in hot weather and invites
weed growth during growing seasons. Follow
local recommendations for the suitable cutting
height in your area.
When operating the mower, move the Lift Control
Lever to the "DOWN" position.
This will allow the mower to follow ground con-
tours.
better to cut
it is
grass
Tips
Extremely tall material should be cut twice. Set
mower at a higher cutting height for the first pass.
Then cut at desired height at 90° to the first pass.
Remember, sharp blades produce cleaner cuts
and require less power.
Analyze area to be cut to determine the best
procedure. Consider height and type of grass and
terrain type: hilly, level or rough.
Plan your mowing pattern to travel straight forward
whenever possible. Mow with uncut grass to the
left. This will distribute the clippings over the cut
area. Discharging clippings over uncut grass will
cause a build-up and may prevent uniform cutting.
Do not operate mower unless
discharge chute and belt shields are in-
stalled.
OPERATION
3 1
Advertisement
Table of Contents
