Table of Contents
Advertisement
Installing
Lift Rods
Tractors Without Rear Three Point Hitch)
(For
1. Adjust the lift rod to 365 mm (1 4.4 in) measured
from
eye to eye as illustrated. Adjustment is
made by turning barrel
tightening nut. Be sure that an equal length
threads shows on either end ,of barrel.
2. Slide eye
of lift rod over pin on tractor lift arm.
Position clevis of lift rod between brackets on lift
link. Note that outside leg of
side of lift link as illustrated. Install with greased
x 76 mm clevis pin with head on left side as
22
shown. Secure both ends with
and linchpins.
NOTE: The eye of the lift rod is not straight. The
curve should point to the inside of the tractor
when properly installed.
rod, then secured by
of
of
rod goes out-
lift
washers
22 rnrn
SET-UP AND ASSEMBLY
I
365 mm
I
in.
14.4
I
(with loader subframe)
I
375 mm
14.8
in.
I
I
i 3
Advertisement
Table of Contents
