Dip-Switch Settings - Martin CX-2 User Manual

DIP-
SWITCH SETTINGS
This section describes how to select the DMX address and special settings using
the DIP-switch on the end panel.
Important! Disconnect the fixture from AC power before changing the
DIP-switch setting. Changes take effect after the fixture has
been turned off and back on.
D M X A D D R E S S S E L E C T I O N
If the CX-2 is to be used with a DMX protocol controller, then the DIP-switch
must be set to a DMX control address. The address, also known as the start
channel, is the first channel used to receive instructions from the controller. The
CX-2 uses 4 channels for full DMX operation. For independent control, each
fixture must be assigned its own address and non-overlapping control channels.
Two CX-2s may share the same address only if they are to respond identically:
they will receive the same instructions and individual control will not be possible.
To set t he DMX address
1 Select an address for the fixture on your controller.
2 Look up the DIP-switch setting for the address on page 11.
3 Disconnect the fixture from AC power.
4 Set pins 1 through 9 to the ON (1) or OFF (0) position as listed in the table.
5 Set pin 10 to the OFF position.
6 Set pin 11 to the OFF position for full 4-channel DMX operation or to the ON
position for 1-channel DMX operation.
10

DIP-switch settings

6
CX-2 user manual