Martin CX-2 User Manual page 12

S P E C I A L S E T T I N G S
DIP-switch pins 1 - 9 are used to select special options in stand-alone and
master/slave mode. To enable these options, pin 10 must be ON.
Pin 11 toggles between 1 and 4 channel DMX control. It must be OFF for
master/slave operation.
Lamp life can be extended by reducing the voltage slightly. Set DIP-switch pin 12
to ON for longer lamp life, or OFF for full output intensity.
Note: the fixture shall be disconnected from AC power when changing DIP-switch
settings. Changes take effect after the fixture has been turned off.
Important! Pin 10 must be ON to enable special settings on pins 1 - 9.
Pin Setting
1 ON
OFF
2 ON
OFF
3 ON
OFF
4 ON
OFF
5 ON
OFF
6 ON
OFF
7 ON
OFF
8 ON
OFF
9 ON
OFF
10 ON
OFF
11 ON
OFF
12 ON
OFF
12
Effect
Music trigger
Automatic trigger
Stand-alone mode on, single or master fixture
Stand-alone mode off / slave fixture
Test program for service use
Normal operation
Slow color and gobo change
Fast color and gobo change
No effect
No effect
Random slave color wheel position (set on slave fixture)
Slave color wheel position same as master
Random slave gobo wheel position (set on slave fixture)
Slave gobo wheel position same as master
Invert slave color wheel position (set on slave fixture)
Slave color wheel position same as master
Invert slave gobo wheel position (set on slave fixture)
Slave gobo wheel position same as master
Enable special settings with pins 1 - 9
Enable DMX address with pins 1 - 9
1-channel mode on
1-channel mode off
Reduced power / longer lamp life
Full power / maximum intensity
DIP-switch settings CX-2 user manual