Martin CX-2 User Manual page 16

The single-channel functions are shown below.
DMX value
0 - 10
11 - 20
21 - 80
81 - 115
116 - 140
141 - 175
176 - 210
211 - 255
S T A N D - A L O N E O P E R A T I O N
The CX-2 automatically operates in stand-alone mode with music trigger if there
is no control signal.
Operation can be modified using the special settings described on page 12. To
enable the special settings, DIP-switch pin 10 must be ON.
Important! The fixture transmits control signals on the data link when
operated in stand-alone mode (with DIP-switch pins 2 and 10
ON). To prevent damage to the electronics, do not connect a
stand-alone fixture to other stand-alone fixtures or to a
controller.
M A S T E R / S L A V E O P E R A T I O N
Multiple CX-2s can be connected together, without a controller, for synchronized
"master/slave" operation in which the slave fixtures mimic the behavior of the
master fixture.
To connect unit s f or master / slave operation
1 Disconnect all fixtures from AC power.
2 Connect the output of one CX-2 to the input of the next CX-2.
3 Connect additional CX-2s output to input. Up to 32 may be connected.
4 Terminate the link on both ends by inserting a female termination plug into
the data input of the first fixture and a male termination plug into the data
output of the last fixture. A termination plug is simply an XLR connector with
a 120 ohm, 0.25 W resistor soldered across pins 2 and 3.
16
Percent Function
0 - 4 Blackout (light off)
5 - 7 Open (light on)
8 - 31 Strobe
32 - 45 Random action with slow music trigger
46 - 55 Random action with medium music trigger
56 - 68 Random action with fast music trigger
69 - 82 Random action with random music trigger
83 - 100 Manual trigger area, crossover at 240 (94%)
Operation CX-2 user manual