Using Multiple Handsets; Registering Handsets - Siemens Gigaset S790 Manual

Deactivating the wake-up call/
repeating after a pause (snooze
mode)
Prerequisite: A wake-up call is sounding.
§Off§
Press the display key. The wake-
up call is deactivated.
or
§Snooze§
Press the display key or any key.
The wake-up call is deactivated
and then repeated after 5 min-
utes. After the second repetition
the wake-up call is deactivated
completely.

Using multiple handsets

Registering handsets

You can register up to six handsets to your
base.
A Gigaset S79H handset can be registered
on up to four bases.
Manually registering a
Gigaset S79H to a Gigaset S790/
S795
You must activate manual registration of the
handset on both the handset (1) and the
base (2).
When the registration process has com-
pleted successfully, the handset returns to
idle status. The handset's internal number is
shown in the display e.g., INT 1. If not, repeat
the procedure. .
Using multiple handsets
1) On the handset
The handset is not registered to a base.
§Register§
Press the display key.
The handset is already registered to a base:
Ï
¢ ¢
v
Registration
¢
Register Handset
If the handset is already registered to four
bases:
s
Select base, e.g., Base 3 and
§OK§
press
~
If required, enter the system
PIN for the base and press
A message appears stating that the hand-
set is searching for a base that is ready for
registration.
2) On the base
Within 60 seconds press and hold the reg-
istration/paging key on the base
¢
( page 4) (approx. 3 seconds).
Registering other handsets
You can register other Gigaset handsets and
handsets for other devices with GAP func-
tionality as follows. .
1) On the handset
¤
Start to register the handset as
described in its user guide.
2) On the base
Press and hold the registration/paging key
¢
on the base ( page 4) (approx. 3 sec.).
.
§OK§
47
.