Uncrate The Snowblower; Remove The Mower Deck; Install The Tension Release Control - Honda SB7038 Operator's Manual

Assembly and Installation
SB7038 Snowblower
Remove the Mower Deck
1. Follow the procedure in the HRC 7000~series Owner's Manual or Shop Manual and remove the
mower deck from the power head.
2. Save the bolts and flange nuts to use with the mower deck when it is reinstalled.
Install the Tension Release Control (hydrostatic drive models)
1. Assemble the pivot pin on the release plate with three 5/l 6" flat washers and a cotter pin as shown.
2. Raise and support the rear of the power unit to reach the pump belt tensioner.
3. Remove the tensioner pivot bolt and belleville washer.
4.
5.
u ./ RIGHT PUMP PULLEY
/
FLANGE NUT
LEFT PUM+ PULLEY
\
/A
3
CRANKSHAFT
PULLEY
\
TENSIONER
\
TENSIONER PIVOT BOLT'
S/32" SPACER
I
Install the belleville washer, release plate, and
spacer over the new pivot bolt.
Install the pivot bolt through the tensioner and
into the engine bed. Install the flange nut on the
tensioner bolt and tighten the bolt.
BELLEVILLE
PLATE
5116" FLAT -
WASHER (3)
PIVOT PIN '