Honda SB7038 Operator's Manual page 15

Assembly and Installation
SB7038 Snowblower
6.
7.
8.
Route the cable behind the fuel tank and above
the the speed control arms. On 7018/20 models,
thread the cable through the same slot on the
fuel support bracket used by the choke and
throttle cables.
On 7013 models, use the 7" cable tie to secure
the cable to the left-side tank support. On
7018/20 models route the cable behind the fuel
pump bracket.
Once the cable has been positioned, install it to the
tighten the bottom jam nut on the T-handle.
9. The cable clamp is keyed to fit a groove on
the cable. Make sure the clamp and cable
are properly aligned before securing the
cable to the discharge chute with the spacer,
two lo-24 screws, lock washers, and hex
nuts.
bracket and
10. Screw the clevis onto the cable. With the chute
held fully down by its springs, and the T-handle
of the cable fully in, adjust the position clevis so
the clevis pin slips through the hole in the
deflector arm.
CLAMP MACHINE
11. Secure the clevis pin with small cotter pin, and
tighten the jam nut against the clevis.
LOCK WASHER (2)
14
POP 52173 (9511)