Honda SB7038 Operator's Manual page 21

Safety Recommendations
SB7038 Snowblower
6.
7.
8.
9.
Inspect the position of the two skid shoes and make sure they
are properly positioned for conditions. Allow l/8" to 3/l 6"
clearance between cutting edge and a level paved surface, or
l/4" to l/2" for an uneven or gravel surface.
Verify the tension on the drive belt is correct. See the mid-sized
commercial mower owner's manual for details on inspecting
and adjusting drive belt tension.
LOOSEN (don't remove) NUTS
If the temperature is extremely cold, it will be easier to start the
engine if you disengage the hydraulic drive pumps. Pull the
hydraulic release rod out, then rotate it so the square plate
holds the rod away from the engine bed.
Follow the procedure in the mid-sized commercial owner's
manual and start the engine.
118 - 3116" LEVEL SURFACE
10. One the engine has started, pull and turn the hydraulic release rod.
114 - 112" GRAVEL OR UNEVEN SURFACE
Operating the snowblower
Read the mid-size commercial mower owner's manual carefully. Be thoroughly familiar with
the controls and proper use of the power head and snowblower. Know how to stop the
snowblower and disengage the controls quickly.
Never allow children to operate the snowblower. Never allow anyone to operate the
snowblower without proper instruction.
Do no allow anyone other than the operator on the snowblower.
Keep the area of operation clear of all people and pets.
Clothing worn by the operator should be fairly tight and belted. Loose clothing should not
be permitted because of the danger of getting into moving parts.
Tie up or restrain long hair.
1. Make sure the area is clear of any people and pets.
2. After the engine has warmed, move the throttle to FAST. Verify the blower head is properly
positioned, then move the blade control lever to ON.
3. Adjust the ground speed as needed. For best performance. the throttle should always be set to FAST.
4. You can adjust the angle and direction of the discharged snow from the operators position.
5. To adjust the discharge angle, turn the T-handle counter-clockwise to unlock it (l/4 turn). Pull the handle to
raise the deflector and push it to lower the deflector. Turn the T-handle clockwise (l/4 turn) to lock the handle.
6. To adiust the discharae direction. rotate the crank handle to turn the discharae chute.