Honda SB7038 Operator's Manual page 13

Assembly and Installation
SB7038 Snowblower
Chute Rotator Assembly
1. Install the crank support on the power head with two 3/8 x 1" bolts and flange nuts.
2. Install the grommet through the hole in the support.
PLASTIC HANDLE
UPPER CRANK ROD
3. Attach the lower crank rod to the worm gear by placing the hook on the lower crank rod through the
hole in the worm gear shaft.
4. Insert the upper crank rod through the grommet in the crank support and into the the lower crank rod.
Secure it with a 2-15/16" spring clip. Install the plastic handle over the end of the upper crank rod.