Snowblower Operation - Honda HS828 Owner's Manual

6. SNOWBLOWER OPERATION
m
Before operating this equipment you should read and unders-
tand the SAFETY INFORMATION on page 3, 4, 5 and 6.
1. Start the engine according to the procedures described on page 21.
2. Move the throttle lever to the FAST position for normal operation.
3.
Release the auger clutch lever, and move the shift lever to select the
desired drive speed.
REVERSE
"N" (Neutral)
SHIFT LEVER
NOTE: Low speed is recommended for removing deep or hard-packed
snow.
4. Set the foot pedal to "HIGH" position (See page 14).
5. Adjust the throwing direction by using the chute crank and the chute
guide. (See pages 9 and 11).
26