Installation Manual - Sharp SF-2014 Service Manual

6. Optional multi bypass feeder unit

Installation Manual

For use with compatible SHARP copiers.
See SHARP copier Installation Manual to determine suitability.
(1) Open the upper unit of the main copier unit.
1 Press the release buttons on the left and right sides of the main
copier unit's front cover, then open the front cover.
2 Push the upper half release lever (green) to the right and down,
then gently open the upper unit.
(2) Release the lock for the manual bypass unit and
remove the manual bypass unit.
1 Release the manual bypass unit by pressing upward on the rock
claws (green; 2 locations) which lock it in place in the main copier
unit's upper unit.
The manual bypass unit will come out toward you slighly.
2 Pull out upon the manual bypass unit to remove it from the main
copier unit.
Manual bypass unit
Rock claw (latch) Rock claw (latch)
(3) Mount the multi bypass feeder unit onto the
main copier unit.
1 Slide the positioning pins which project from the multi bypass
feeder unit in to the grooves in the main copier unit, then push the
multi bypass feeder unit into place to in stall it.
At this time, to be sure that the multi bypass feeder unit is securely
installed, push down once more on the fourcorners of the unit. (If it
has not been securely installed, "CH" may appear in the COPIES
MADE display when the power is turned on.)
Rock claw (latch)
Rock claw
(latch)
2 Close the upper unit of the main copier unit.
4 – 8
Multi bypass feeder unit
Positioning pins
Positioning pins
Multi bypass
feeder unit