Toner Density Sensor Level Check; Accessory Attachment; No.2/No.3 Mirror Unit (Mirror Base B) Lock - Sharp SF-2014 Service Manual

Table of Contents

Advertisement

Turn the toner cartridge counterclockwise to lock it in position
4 Supply toner.
Remove the toner cartridge sheet and supply toner.
(Toner will be supplied.)
Return the toner cartridge to the original position and close the
front cabinet.

(5) Toner density sensor level check

1 Turn on the power switch of the copier.
2 Adjust the developer level.
(a) Perform the key operations of simulation 25 sub 2.
C
0
0
C
2
5
2
With the above key operations, simulation 25 is performed and
the developer is stirred for 3 minutes.
(b) After stirring the developer for 3 minutes, the toner density
level is read by the main PWB.
During stirring, the toner density sensor level is displayed on
the MULTI COPY display. (Range: 1 ∼ 99)
[Note] If the simulation is cancelled during execution, the au-
tomatic reading cannot be performed. Do not cancel
the simulation during execution.
(c) Press the CLEAR key three times to cancel simulation 25.
c
c
c

(6) Accessory attachment

1 Attach the copy tray.
2 Attach the document tray.
[SF-2214 only]
2
1
4. Locking procedure for transit or
repacking
In general, reverse the procedures in "3. Installation procedure." For
the optical system lock, perform the following procedure.

(1) No.2/No.3 mirror unit (Mirror base B) lock

1 Perform locking with the unit at its home position (normal copy
position) with the power ON and with the mirror stopped and with
the external covers installed.
2 Lock the unit with the mirror unit fixing screw. (The hole in the left
cabinet)
Mirror unit fixing screw
4 – 5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sf-2114Sf-2214

Table of Contents