Specifications; Introductions - WAGNER Fine Finish Stati-Kit 2000 0292003 Owner's Manual

SPECIFICATIONS

GM2000 EAC SPRAYGUN (P/N 0179673)
Air Pressure, max.
Material Pressure, max.
Air Volume
Material Volume
Air Connector
Material Connector
Length
Height
Weight
Input voltage
Input Current, max.
Frequency
High Voltage
Output Current, max.
Polarity
Cable, Connecting
VM200 ELECTROSTATIC POWER PACK
(P/N 0179637)
Length
Width
Height
Weight
Input - VAC
Power consumption max.
Output Voltage
Output Current max
Output Frequency
Power Cord
Use only coating materials with a specific re-
sistance of 50 - 3.500 K Ohms . If you are not
sure of the specific resistance check with the
coatings supplier before using.
145 psi
3625 psi
10 CFM@ 45 PSI
Varies due to Tip size
1/4 inch
NPS 1/4
11.8 inches
10 inches
21 oz.
22 VAC
0.8 A
26 kHz
80 kV DC
100 A AC
Negative
36 ft.
7.5 inches
4.75 inches
3.5 inches
3.9 lbs.
110 - 60 Hz
15 W
80 KV
0.7 A
17 kHz
9 ft.
NOTE
INTRODUCTION
INTRODUCTION TO ELECTRO-STATIC
SPRAYING
The spraying medium is atomized using a pneumatic or
diaphragm pump and a booster air feed supply. A high DC
voltage (up to 80 kV), applied across the grounded compo-
nent and the electrode fitted to the gun body generates an
electric field and applies a negative charge to the paint
particles. These repel each other as they move from gun to
workpiece and so distribute evenly through the fine spray
cloud and then uniformly deposit on the positively grounded
surface. Particles shooting past the component remain
trapped in the electric field and deposit on the backside of
the work object. Effective material yield up to 90%, time
savings up to 80%, markedly improved quality of finish, less
cleaning and a healthier environment are the principal
properties of the process.
FEATURES:
Minimum overspray
Coating by electrostatic wrap-around action
Good atomization of charged particles
ADVANTAGES:
Effective material utilization up to 90%
Enormous time and labor savings
7
1