Specifications - WAGNER AG-08 Owner's Manual

6. The objects being sprayed must be earthed.
7. Before each use, check all hoses for cuts, leaks, abrasion or bulging of cover. Check for
damage or movement of couplings. Immediately replace the hose if any of these conditions
exist. Never repair a paint hose. Replace it with another grounded high-pressure hose.
8. Pulling the trigger causes a recoil force to the hand that is holding the spray gun.
The recoil force of the spray gun is particularly powerful when the tip has been removed and
a high pressure has been set on the airless high-pressure pump. Therefore, when cleaning
without tip set the pressure control valve to the lowest pressure.
9. Use only manufacturer authorized parts. User assumes all risks and liabilities when using
parts that do not meet the minimum specifications and safety devices of the spray gun
manufacturer.

Specifications

Maximum operating pressure ...................................................................... 25 MPa (3600 PSI)
Material inlet thread size .............................................................................. M16 x 1.5
Diffuser thread size ....................................................................................... 7/8 - 14 UNF-2A
Wetted parts material ................................................................................... High-grade steel
Operating temperature range ...................................................................... 5ºC to 40ºC
Maximum material temperature ................................................................... 43ºC (109ºF)
Maximum sound output................................................................................ 81 dB(A)*
Weight ............................................................................................................ 450 g (1 lb.)
* Measurement location: 0.5 m away from the coating surface, 0.5 m behind the spray gun,
spray pressure 12 MPa, tip size 0.021
AG-08
GB
(NPSM 1/4")
aluminum
Teflon
hard metal
(40ºF to 104ºF)
11