Leveling The Cutter Deck - Honda H5518 Operator's Manual

8. Leveling the cutter deck
- 1. Place the tractor on a firm, level surface and lock the parking brake.
Turn the steering wheel so that the wheels are in the straight-ahead
position. Check the air pressure in the tires.
Tire pressure: Front (1 .O kg/cm*, 14.2 psi)
Rear (0.8 kg/cm*, 11.4 psi)
- 2. Check that the gauge rollers are at the 2-l/2" position. If not, raise the
cutter deck with the hydraulic lift lever; turn the descent speed ad-
just knob fully clockwise; stop the engine and remove the key;
remove and relocate the pin to the 2-l/2" position; return the descent
speed adjust knob to its original position; lower the cutter deck fully.
m The cutter deck will automatically lower to the ground as the
descent speed adjust knob is turned counterclockwise. Keep clear of the
deck.
LINK PIN
LOCK PIN
- 3. Front-to-back leveling:
Measure the distance from the bottom of the cutter deck housing to
the ground at the points A/B and C/D.
The distance between point A/B and C/D should not exceed:
59.5-63.5 mm (2.3-2.5 in)
FRONT
A,8dc,D