Cutter Deck Removal - Honda H5518 Operator's Manual

3. Cutter deck removal
-
1. Start the engine and move the hydraulic cylinder selector lever (op-
tional part) to the "FRONT" position. Raise the cutter deck by using
hydraulic lift lever.
-
2. Stop the engine and remove the engine switch key.
-
3. Set the gauge wheel to the 1 l/2 position (See page 33).
-
4. Lower the cutter deck; turn off the engine, remove the ignition key
and disconnect the spark plug caps.
m
To avoid severe personal injury remove the ignition key
and disconnect the spark plug caps to prevent accidental starting.
-
5. Remove the cutter deck drive belt from the pulleys. (See page 45).
-
6. Disconnect the front deck links by removing 14 mm plain washers
and linch pins on each side of the cutter deck.
LINCH PINS
LINCH PIN
14 mm PLAIN WASHER
T DECK LINKS
-
7. Disconnect the cutter deck lift plates and rear deck links by removing
the 14 mm lock pins, washers and linch pin from the cutter deck.
REAR LINK SHAFT
CUTTER DECK LIFT PLATE
REAR
46
DECK LINKS
LOCK PIN
PLAIN WASHER