Weider Power Tower WEBE99712.0 User Manual page 9

6. Attach a Dip Arm (5) to one of the Pull-up
Frames (3) and one of the Uprights (2) with two
M8 x 75mm Bolts (17), a Support Plate (13),
and two M8 Locknuts (22); do not tighten the
Locknuts yet.
Repeat this step with the other Dip Arm (5).
7. Attach the Top Crossbar (7) to one of the Dip
Arms (5) with two M8 x 75mm Bolts (17), two M8
Washers (23), and two M8 Locknuts (22); do not
tighten the Locknuts yet.
Attach the Top Crossbar (7) to the other Dip
Arm (5) in the same way.
8. Attach the Pull-up Bar (9) to the Pull-up Frames
(3) with two M10 x 50mm Screws (19) and
two M10 Washers (26). Make sure that the
indented holes in the Pull-up Bar are on the
side shown. Then, press the two Rubber Caps
(12) into the ends of the Pull-up Frames.
See steps 2––7. Tighten all of the M8 Locknuts
(22).
6
5
7
5
8
Indents
3
9 9
3
22
13
2
22
5
7
22
5
23
19
12
26
9
26
3
Meijer.com
17
23
17
12
19