COPYWRITER PRO SERIES DUPLICATOR
Error Messages
If any failure occurs during operations, an error message on LCD and a beep indicate as it is the
error. It beeps every two seconds which keep beeping until it stops. Opening a tray of drive
having the error stops beeping.
Descriptions for each error message are as follows:
ERROR MASTER
ERROR TARGET XX
CODE XXXX
MASTER ANALYZE
VERIFY DATA
CANNOT VERIFY
DISC TYPE
USER STOP
DATA SIZE
TIME OUT
SYSTEM ERROR
MASTER NOT FOUND
PROGRAM SUM
PROGRAM DISC
VERSION UP ERROR
ATAPI BUS
MICROBOARDS TECHNOLOGY, LLC
: Error during COPY/ VERIFY/ READ
CHECK with Master Drive
: Error during COPY/ VERIFY/ READ
CHECK with Target Drive No. XX.
: ATAPI error code XXXX occurred.
: Error while analyzing a master disc
: Error during VERIFY
: CD-DA or CD-ROM XA is tried to VERIFY.
: Unable to analyze a format of master data, or
not available format
: Cancel by an user, or unable to proceed an
operation any more
: No match in capacities between a master disc
and copied disc (s) during VERIFY
: Time out error
: Failed to boot up
: Master Drive not connected, or not recognized
: Problem with the copy program in Flash ROM
: Not proper firmware disc for DSR-2300
: Failed to load firmware
: Problem with response from drive
16