Table of Contents
Advertisement
Appendix 2: Error Messages
Master Discs should always be clean and free from scratches to reduce the number of
duplication failures.
If an error situation occurs during duplication, the display will show both an error code and an
error message.
Error
Error Message
Code
200
Source Disc Empty
201
Bad Master
202
No Targets!
Burner Mixed or
203
Firmware Version
Mixed
Targets & Master Not
204
Compatible!
205
Targets Not Blank!
Targets & Master Size
206
Mismatch!
Targets are not RW
208
Discs!
Master Disc is CSS
209
Protected!
210
Bad Discs!
This format can not be
211
tested!
251
Copy Audio Error
252
Not Audio CD
Description and Recommended Solutions
The master disc was detected and identified successfully,
but is blank.
Check the master to ensure it contains data.
The master disc is detected but can't be identified.
Check the master disc for defects or errors.
All blank discs are missing once the job has already
started.
Verify that blank discs are loaded into the recorders.
The model or firmware versions of all installed recorders
are not the same.
Drive may have been replaced.
Support.
The master disc and target discs do not have the same
format.
Verify that the master and target discs are the same
format (CD master and CD blanks, for instance). You
can use Disc Info in the Utilities menu to verify the disc
formats.
Existing data has been detected on the target discs.
Verify the discs are blank, replace if not.
During Compare: The sizes of the master disc and
successful copies are different.
During Copy: The capacity of the blank discs is less than
the data size of the master.
During Compare: Contact Tech Support
During Copy: Use Disc Info in the Utilities menu to
verify that the blanks capacity is large enough for the
data on the master disc.
The target discs are not Rewritable during an Erase
attempt.
Verify that each loaded disc is rewritable.
The master disc is copy protected.
Copy protected masters cannot be duplicated.
The target discs are detected but cannot be identified.
Replace discs that cannot be identified.
Target discs during a Test attempt are DVD+R,
DVD+RW, DVD+R DL, BD-R, or BD-RE.
Disc formats listed above are not supported by the
test function.
Applies to Mix Audio Tracks. An error occurred during
the Mix Audio process. Could be caused by either a
master error or a recording error.
Try a different master or blank disc.
Applies to Mix Audio Tracks. The master disc is not an
Audio CD.
Verify the master disc is an Audio CD.
25
BD Pro Series
Contact Tech
Advertisement
Table of Contents
