Optional Video Unit Function - Hitachi 37PD5000 User Manual

Optional Video Unit Function

Additional functions when the optional video unit is installed are as follows: (
COMPONENT NAMES
Remote control (provided for the optional video unit)
This type of remote control would be provided for the optional video unit as the substitute for the one shown in page
POWER ON / OFF button
PICTURE MODE button
RECALL button
INPUT SELECT button
MENU button
DVD CONTROL buttons
Loading Batteries
1. Open the battery cover.
• Slide back and remove the battery
cover in the direction of the arrow.
2. Load batteries.
• Load two Size AA batteries included
observing the correct polarities.
3. Close the battery cover.
• Replace the battery cover in the
direction of the arrow and snap it back
into place.
CAUTION
• Do not use new and old batteries together. The batteries could
explode or leak, resulting in fires, physical injury, or stains.
• When loading batteries, observe their correct polarities as marked
on the product. If loaded in the wrong direction, the batteries
could explode or leak, resulting in fires, physical injury, or stains.
D / N
i +
MENU
-
D V D
OK button
1
4
7
AV1 AV2
)
AUDIO MODE button
MULTI PICTURE (PinP) button
I / II
Buttons for MULTI PICTURE mode
A / B 2-4-12
RETURN button
P+ SELECT / ADJUST buttons (
+
OK
VOLUME UP / DOWN buttons
P-
MUTE button
FREEZE
FREEZE button
ZOOM
ZOOM button
2 3
5 6
8 9
0
AV3 AV4
RGB / VIDEO buttons
RGB1 RGB2
Handling the Remote Control
Use the remote control within about 5 m from front of the unit's
remote-control sensor and within 30 degrees on both sides.
With in 30
degrees
About 3m
About 5m
D / N
i + I / II
MENU A / B 2-4-12
P+
- +
OK
P-
D V D
FREEZE
ZOOM
1 2 3
4 5 6
7 8 9
0
AV1 AV2 AV3 AV4
RGB1 RGB2
ATTENTION
• Do not drop or impact the remote control.
• Do not splash the remote control with water or put it on a wet
object to avoid possible failures.
• Before leaving the remote control out of use for an extended
period of time, remove the batteries from it.
• If the remote control begins to lack responsiveness, replace the
batteries.
• Strong light such as direct sunlight impinging on the
photoreceptor of the remote control can cause operational
failure. Position this unit to avoid direct contact with such light.
.
)
With in 30
degrees
About 3m