Hitachi 37PD5000 User Manual page 42

OPERATING INSTRUCTIONS (continued)
SETUP MENU
Picture
Audio
Timer
MENU
Function
Setup
Language
Select
OK Set
Selected characters
System
Color System
System1
AV1
System2
AV2
AV3
AV4
Video Input
AV1
RGB
AV2 (1st step)
AV2 (2nd step)
AV4
OK
System1 System2
Auto PAL SECAM
NTSC3.58 NTSC4.43
Auto NTSC-M
PAL-N PAL-M
Auto HDTV SDTV/DVD
Composite/Component
Auto HDTV SDTV/DVD
S.Video Composite
Setup
System System 1
OK
Color System
Video Input
Audio Input
Scart Output Monitor
RGB1 DVI-STB
RGB2 Component
HDTV
Select OK Set Return
Setup
System System 1
Color System OK
Video Input
Audio Input
Scart Output Monitor
RGB1 DVI-STB
RGB2 Component
HDTV
Select OK Set Return
Setup
System System 1
Color System OK
Video Input
Audio Input
Scart Output Monitor
RGB1 DVI-STB
RGB2 Component
HDTV
Select OK Set Return
Setup hint
System1 : Europe/Asia, System2 : North America
This should correspond to the color system of the signal from the
equipment that is connected to AV1 video input terminal.
• Normally, set this to Auto. The system of the input signal will be
automatically recognized.
• If the input signal contains much noise or has a low level at Auto and the
operation is found erratic, set this to match the input signal.
• When the component signal is received, this would be not available
(grayed out).
(Same to AV1)
This should correspond to the signal mode of the signal from the
equipment that is connected to AV1 video input terminal.
• Normally, set this to Auto. The signal mode of the input signal will be
automatically recognized.
• If the input signal contains much noise or has a low level at Auto and the
operation is found erratic, set this to match the input signal.
This should correspond to the signal mode of the signal from the
equipment that is connected to AV2 video input terminal.
This step should be set only when [Composite/Component] is selected on
the 1st step. And the procedure is same to AV1.
• If the signal from the equipment that is connected to AV4 Scart input
terminal is S.Video or Composite, set this to correspond to that signal.
• If the signal is RGB, it will be automatically recognized and this setting
will have no effect.
Setup
Color System
AV1 Auto
AV2 PAL
AV3 SECAM
AV4 PAL
Select Return Exit
Setup
Video Input
AV1 Auto
AV2 Composite/Component
AV3 Auto
AV4 S.Video
Select Return Exit
Setup
Audio Input
AV1 Stereo
AV2 L/Mono
AV3 Stereo
AV4 L/Mono
Select Return Exit