Optional Video Unit Function - Hitachi CMP420V1 User Manual

Optional Video Unit Function

Additional functions when the optional video unit is installed are as follows: (
INSTALLATION INSTRUCTIONS
Connecting to a Video Imaging Device
(1) Make sure that the power switch of the monitor is turned off.
(2) Make sure that the power switch of the imaging device is turned off.
(3) Use a commercially available cable and connector to connect the signal input terminal on the rear panel of this
device and the signal output terminal of the imaging device.
VCR
S-video/Composite video
Do not connect both
plugs at the same time.
Use either of them.
Video disc player
With DVI-STB and RGB component setup
Applicable video signals for each input terminal (See PRODUCT SPECIFICATIONS for details.
Terminal
Signal CVBS S-video
AV1
AV2
AV3
AV4
RGB1
RGB2
20 18 16 14 12 10 8 6 4 2
21 19 17 15 13 11 9 7 5 3 1
Adaptor
VCR
To component video
equipments.
Please use the connection
cable suitable for the terminal
form of video equipment.
RCA/SCART
Component RGB
Speaker (R)
Power
cord
Use if the
video
equipment
[An example of connecting video imaging devices]
has an
S video
input terminal
• If video equipment with an S video output terminal is used, cabling
by the S video cable is recommended to provide finer video
quality. (If the S video input terminal and the video input terminal
of AV3 connect to the monitor at the same time, S video input
would govern.)
• If the OUTPUT (MONITOR) terminal is connected to an external
monitor with a 75 Ohm terminal, it is possible to view the same
image as on the main unit. But it is possible to monitor only the
composite video signal from AV1, AV2, AV3 or AV4 input that is
displayed on the screen at the time.
• If the adaptor is applied to AV4 input as shown in the drawing, it is
impossible to receive RGB signal.
DVI D-sub
PC STB RGB Component
)
Monitor rear panel
DVD player Set-Top Box
Remarks
Refer to Setup Menu.
Refer to Setup Menu.
Refer to Setup Menu.
Refer to Setup Menu.
Speaker (L)
)
(