22 | HVE1/HVE4/HVE8 Encoders Getting Started Guide
Modifying Network Parameters
1.
Click to select a connected device from the device list the device. The network parameters for the selected device
will appear in the Modify Network Parameters panel on the right side.
2.
Configure the network settings.
•
Automatically – Click to select Obtain an IP Address automatically, enter the Device Name, then click Apply.
The network settings are automatically assigned from the network server.
•
Manually – Click to deselect Obtain an IP Address automatically, then enter the Device Name, IP Address,
Subnet Mask, and Gateway. Then click Apply.
www.honeywell.com/security
Note
You can click Up or Down buttons on each column heading to reorder the
information. Click >> to expand the device table, and to hide the network
parameter panel on the right side. Click << to show the network parameter
panel.
Figure 12
Editing Network Parameters in the Modify Network Parameters Window