Table of Contents
Advertisement
5.
WATER AND MOISTURE - Do not use this unit near water or in an unprotected outdoor installation, or any area
classified as a wet location.
6.
MOUNTING SYSTEM - Use only with a mounting system recommended by the manufacturer, or sold with the
product.
7.
ATTACHMENTS - Do not use attachments not recommended by the product manufacturer as they may result in
the risk of fire, electric shock, or injury to persons.
8.
ACCESSORIES - Only use accessories specified by the manufacturer.
9.
CLEANING - Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
10. SERVICING - Do not attempt to service this unit yourself as opening or removing covers may expose you to
dangerous voltage or other hazards. Refer all servicing to qualified service personnel.
11. REPLACEMENT PARTS - When replacement parts are required, be sure the service technician has used
replacement parts specified by the manufacturer or have the same characteristics as the original part.
Unauthorized substitutions may result in fire, electric shock or other hazards.
Installation
The HVE1(X)/HVE4(X)/HVE8(X) encoders are highly advanced surveillance equipment that should be installed with
care. Please ensure that you install a manufacturer-recommended HDD (HVE8(X) models only). See
of recommended HDDs.
During encoder installation:
•
Use brackets for racking mounting.
•
Ensure that there is ample room for audio and video cables.
•
When installing the cables, ensure that the bend radius of the cables is no less than five times its diameter.
•
Connect both the alarm and the RS-485 cable.
•
Allow at least 2cm (~0.75 inch) of space between rack-mounted devices.
•
Ensure that the encoder is grounded.
•
Ensure that the environmental temperature is within -10°C–55°C (14°F–131°F).
•
Ensure that the environmental humidity is within 10%–90%.
Installing the Hard Disk Drive (HDD)
This section applies only to HVE8(X) models that have room for a Hard Disk Drive (HDD) for recording.
Preparing for Installation
This encoder comes from the factory without a HDD. Follow these instructions to install a HDD that is appropriate for
your situation according to the total capacity calculated in terms of the Schedule Recording Settings. The installation
and removal of the hard disk should be done by qualified professionals.
| 11
Table 1-1
for a list
800-15611V2 - A - 10/2013
Hide quick links:
Advertisement
Table of Contents
