Honeywell HVE1 Getting Started Manual page 7

2. Place the HDD into the slot on the chassis, and then secure it in position by tightening the screws at the bottom
of the chassis.
Install
3. Remove the HDD data line from the accessories box. Plug one end of the data line to the circuit board, and the
other end to the data line port on the HDD. Connect the power cord to the HDD in the same way.
Connect the power cord
4. Replace the chassis cover, and then tighten the screws on both sides and the rear panel of the encoder.
Figure 1 Removing the Cover
Figure 2 Installing and Securing the HDD
Figure 3 Connecting the Data Line and the Power Cord
| 13
Secure
Connect the data line
800-15611V2 - A - 10/2013