Table of Contents
Advertisement
1.
Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 1)
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
2.
To make fan operational, install two 3-volt batteries
in hand-held remote transmitter, (if not using for long
periods of time, remove battery to prevent damage to
transmitter). Store the remote away from excessive
heat or humidly. (Figure 2)
3.
The hand-held remote transmitter includes buttons
for high, medium and low fan speeds as well as fan
off, light on/off and reverse. Infinite light levels are
available by holding the light on/off button. (Figure 3)
4.
If airflow is desired in the opposite direction, turn
the fan off and wait for the blades to stop turning.
Then slide the reverse switch on top of motor
assembly to the opposite position and turn fan on
again. (Figure 4)
Reverse Switch Information
Season
Rotation Direction
Summer
Counter-Clockwise
Winter
Clockwise
1. Periodic cleaning of your new ceiling fan is the only
maintenance that is needed. When cleaning, use
only a soft brush or lint free cloth to avoid
scratching the finish. Abrasive cleaning agents are
not required and should be avoided to prevent
damage to finish.
Periodic light dusting of the blades is recommended.
A feather duster will work best.
How to Operate Your Ceiling Fan
Switch Position
Left
Right
Maintenance
Blade Cleaning
3V, CR2032
BATTERY
(2 PCS)
REMOTE
CONTROL
REMOTE
CONTROL
Do not use water when cleaning your ceiling fan.
It could damage the motor or the finish and create
the possibility of electrical shock.
Avoid using water, cleansers, or harsh rags, which
can warp and ruin the finish.
12
MAIN FUSE BOX
Figure 1
Figure 2
Figure 3
Switch
Reverse
Figure 4
CAUTION
Advertisement
Table of Contents
